Inserting The Modules - Bosch REXROTH SB356 Manual

3 609 929 B67/2008-11 | SB356

Inserting the modules

Insert the individual modules (SE352(M),
KE350(G IL), LTU350/1, LT35x, NK350(S))
in the SB356 as shown in Fig. 4.
SE LT LT
*Tightening channel: SE352(M) tightening controller
+
LT35x/LTU350/1 servo amplifier
Fig. 4: SB356 slots for individual modules
Slots 1-6 in the system box can be equipped
with a tightening channel (LT35x, LTU350/1,
SE352(M)). The KE350(G IL) must be
inserted in the KE slot (on the right of the
system box). If several system boxes are
networked via a NK350(S) network coupler,
the KE350(G IL) must be inserted in the
system box, which also contains the NK350S
network coupler.
A maximum of one KE350(G IL) and 40
tightening channels can be operated in one
tightening system.
The outer right slot is intended exclusively for
the NK350(S) network coupler.
Tightening
channel*
Slide the individual modules along the upper
Tightening
and lower guides.
channel*
Tightening channel*
The modules should be completely inserted
or KE350(G IL)
into the SB356 and secured with the knurled
bolts.
For safety reasons and EMC regulations,
close off unoccupied slots using dummy
panels.
Mains connection
The power connections have been designed
according to requirements for category 3
overvoltage.
NK350(S)
Tightening
channel*
Tightening channel*
Tightening channel*
VM350
Bosch Rexroth AG
CAUTION
Risk of damage to persons
and property!
The system box may only be
operated in grounded networks.
Operation in networks that have
not been directly grounded (IT
networks) is not permitted, as air
paths and creepage distances in
the module may be overloaded.
31/124