IndraControl L40
4
Technical Data
4.1
Equipment
Processor
Main memory
Interfaces
Interface to
functional modules
Interface to I/O
modules
Communication
interfaces
Ready contact
Inputs and outputs
4.2
Voltage Supply
DOK-CONTRL-IC*L40*****-PR02-EN-P
IAS COMPONENTS www.ias-components.com info@ias-components.com
National Geode SC1200, at least with 266 MHz
At least 32-Mbyte DRAM and at least 64-kbyte NvRAM
•
Bosch Rexroth PC104
•
Rexroth Inline interface
•
1 x Ethernet connection (RJ 45, 10/100 Base-T)
•
1 x serial RS232 interface
Optional:
•
1 x PROFIBUS DP master-slave interface
•
1 x SERCOS master interface
Optional:
•
1 single-pin Ready contact
•
8 electrically isolated digital inputs
•
8 electrically isolated digital outputs
The IndraControl L40 is supplied with a voltage of 24 V. The following
values of the operating voltage comply with DIN EN 61131-2:
Nominal value
Tolerances
Residual ripple
Umax
Umin
Fig. 4-1:
Operating voltage according to DIN EN 61131-2
The IndraControl L40 requires three operating voltages (see Section
"External Supply Voltages" on page 7-2). Current consumption from these
voltages is as follows:
Current consumption by U
LS
Current consumption by U
M
Fig. 4-2:
Current consumption
Plus
24 VDC
-15 % / +20 % (without residual ripple)
+/- 5 %
30 V
19.2 V
Max. 3 A
and U
Max. 8 A in total
S
4-1
Technical Data