Connections And Interfaces; Overview Of Connections On The Front - Bosch Rexroth IndraControl L40 Project Planning Manual

IndraControl L40
7

Connections and Interfaces

7.1

Overview of Connections on the Front

Des. on the Type of connection
housing
X3C Serial RS232 interface
X7E Network connection:
Ethernet 10Base T / 100Base X
X7P DP: PROFIBUS DP slave
X7S2 SERCOS TX
X7S1 SERCOS RX
X2R Ready contact
compact flash card
DOK-CONTRL-IC*L40*****-PR02-EN-P
IAS COMPONENTS www.ias-components.com info@ias-components.com
Type of connector (integrated) Mating connector or cable
D-Sub male connector, 9-pin
RJ45 female connector, 8-pin
D-Sub female connector, 9-pin
Female optical fiber connector
Female optical fiber connector
3-pin male connector strip, 3.5 mm
Slot for
Fig. 7-1: IndraControl L40 connections
CAUTION
Connections and Interfaces
1 2
Eight digital
inputs
Fitting or removing connectors with the
IndraControl L40 being live may damage the
unit or an additional module!
⇒ Turn off the supply voltage before establishing or
breaking any connections!
(from outside)
D-Sub female connector, 9-pin
RJ45 male connector (8-core twisted
pair)
D-Sub male bus connector IP20, 9-
pin
Male FSMA optical fiber connector
Male FSMA optical fiber connector
3-pin female connector strip, spring
force, 3.5 mm (included in scope of
delivery)
4 5
3
Eight digital PWR IN
outputs Power supply
Anschluesse.FH9
7-1