Dismounting The Indracontrol L40; Fig. 8-1: Before Dismounting The Indracontrol L40, The First Rexroth Inline - Bosch Rexroth IndraControl L40 Project Planning Manual

8-2
Installation and Maintenance
Attaching the End Clamps /
CLIPFIX Clamps

Dismounting the IndraControl L40

Disconnecting the Additional
Modules from the
IndraControl L40
Removing the First Rexroth
Inline Module
Removing the IndraControl L40
from the Top-hat Rail
IAS COMPONENTS www.ias-components.com info@ias-components.com
Attach the end clamps to either side of the Rexroth Inline station. These
end clamps ensure that the station is securely mounted to the top-hat rail
and are also provided as lateral termination elements. These termination
elements are included in the scope of delivery of the IndraControl L40.
To dismount the IndraControl L40, first disconnect the additional modules
mounted to the left of the IndraControl L40 from the latter. First remove
the left-hand end clip (CLIPFIX) and slide the additional modules along
the top-hat rail to the left until you have severed the plug connection of the
PLUS
PCI bus.
Thereafter, remove the first Rexroth Inline module that is mounted to the
right of the IndraControl L40. Proceed as follows:
• Remove the labeling field, if present.
Note: If any of the modules is provided with more connectors than
one, all of these connectors must be removed from the
module.
• Pry out the connector of the module to be removed by pressing on the
rear connector shaft latch.
• Remove the connector(s).
• Remove the power plug from the IndraControl L40. This ensures that
the feathers of the voltage jumpers and the keyway / feather key joint
are prevented from damage. Moreover, this provides more space for
accessing the module.
• Actuate the release mechanism (1 in Fig. 8-1) and remove the
electronic socket perpendicularly to the top-hat rail (2 in Fig. 8-1).
Fig. 8-1: Before dismounting the IndraControl L40, the first Rexroth Inline
module must be removed.
You can now remove the IndraControl L40 from the top-hat rail by
loosening the fixing claw on the bottom side by means of a tool
(screwdriver) and pulling the IndraControl L40 off the top-hat rail from
below, tilting it and removing it upwards.
IndraControl L40
Demontage.FH9
DOK-CONTRL-IC*L40*****-PR02-EN-P