Dismounting And Changing The Inline Terminals - Bosch Rexroth IndraControl L25 Instruction Manual

36/65 Bosch Rexroth AG
Mounting, Dismounting and Electrical Installation
10.6

Dismounting and changing the Inline terminals

Removing an Inline terminal
① Release lever
Fig.10-19: Position of the release lever
2. Tilt the control upwards (C in 10-20).
Fig.10-20: Dismounting the control from the top-hat rail
3. Remove the control by pulling it diagonally upwards (C in 10-20).
1. Remove the labeling field, if present (A1 in 10-21).
Remove all connectors of the terminal. The sections below de‐
scribe how to remove a 2-slot terminal.
2. Pry out the connector of the terminal to be removed by pressing on the
rear connector shaft latch (A2 in 10-21).
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
1