Installing And Removing Drives - Epson ActionTower 2000 User Manual

Hide thumbs Also See for ActionTower 2000:
Table of Contents

Advertisement

Chapter 4

Installing and Removing Drives

This chapter describes how to install and remove optional
drives in your computer. You can use these instructions to
install a variety of devices, including hard disk drives, a
diskette drive, a tape drive, a CD-ROM drive, or an optical
drive. Although your drive may look different from the ones
illustrated here, you should be able to install it the same way.
Your computer can hold up to seven mass storage devices, as
described in the table below.
Drive bay
Fourexternally accessible
bays
One front internal bay
Two rear internal bays
Note
The main system board in your computer supports up to
two diskette drives (or one diskette drive and one tape
drive) and up to two IDE hard disk drives. If you install
more than four drives, you must install a drive controller on
an option card, such as a SCSI controller card, for the
additional drive(s).
Drive type and size
Two 5.25-inch, half-height drivesor
one 5.25-inch, full-height drive
and two 3.5-inch, third-height drives
One 3.5-inch, half-height orthird-height
drive
Two 3.5-inch, half-height orthird-height, or
one 3.5-inch, full-height drive
Installing and Removing Drives
4-1

Advertisement

Table of Contents
loading

Table of Contents