Exiting Setup; Post-Setup Procedures - Epson ActionTower 2000 User Manual

If you enable the
one wait state in a 16-bit ISA cycle rather than providing the
fastest processing at zero wait states.
The Slow Refresh option, when enabled, improves system
performance because it shortens the time needed for each
refresh cycle.

Exiting SETUP

When you leave SETUP, you can save your settings and reboot
your system, or exit SETUP without saving your settings. You
can also return all values to the factory defaults.
To leave SETUP, press E
Exiting SETUP menu, you can press these keys:
Esc
F4
F5
F6

Post-SETUP Procedures

After you run SETUP for the first time, you may need to install
the operating system on your computer if your system is not
preconfigured. Make sure your hard disk drive is partitioned
and formatted for the operating system you plan to install. See
your operating system manual for instructions.
1 wait state option, the system inserts
ISA
Returns to SETUP
Saves the changes you have made to your
configuration and restarts your computer
Supplies the factory default values for all options
Exits SETUP and returns to the system prompt
without saving any changes.
from any SETUP screen. From the
SC
Setting Up Your System 1-17