Removing Mounting Frames - Epson ActionTower 2000 User Manual

If you are installing the first hard disk drive in your computer,
you don't need to change these jumper settings. If you are
installing a second hard disk drive, see the table labeled "IDE
hard disk drive jumper settings" in Appendix A for the correct
jumper settings.

Removing Mounting Frames

If you are installing a drive in a 31/2inch wide drive bay and
there are mounting frames attached to the drive, you must
remove them before you install the drive. Follow these steps:
1. On your drive, there may be a plastic guiderail and metal
grounding plate attached to one of the mounting frames. If
so, remove the screws securing them to the mounting
frame and remove the guiderail and grounding plate.
2. Then remove the two screws securing each mounting frame
to the drive and remove the frames.
Installing and Removing Drives 4-3