Epson ActionTower 2000 User Manual page 66

2. If there is an option card in the way, remove it. See page 3-18
for instructions. If necessary, disconnect any drive ribbon
cables to move them out of your way. (See Chapter 4).
3. Remove the processor from its package and inspect it. If the
pins appear bent or crooked, do not install the coprocessor.
You may need to replace it.
4. Position the coprocessor chip over the socket, aligning the
notched edge of the chip (marked with a dot) with the
bevelled corner in the socket, as shown below. Then gently
push the coprocessor straight into the socket, pressing
evenly and firmly on all sides.
Caution
If you install the chip in the wrong orientation, you may
damage the chip and void your warranty.
5. Replace any option cards you removed. See page 3-15 for
instructions.
6. Replace any drive ribbon cables you disconnected. Then
replace the computer's cover.
Installing and Removing Options
3-21