Epson ActionTower 2000 User Manual page 74

8. Position the connector on the drive ribbon cable so the red
wire aligns with the side of the drive connector containing
pin 1. Make sure the holes in the ribbon cable connector fit
over all the pins; then push in the connector.
9. Locate one of the cables that lead from the power supply.
(They have multi-colored wires and a plastic connector on
the end.) Align the notched corners of the power supply
connector and the drive's power connector; then push in
the connector.
Note
The power supply has two small and three large cables.
If you need another cable, you must use a Y cable, which
allows you to create two cables from a single cable.
Most computer accessory stores carry Y cables.
10. If you have finished installing or removing drives, replace
the computer's cover (described in Chapter 3) and see page
4-19 for post-installation instructions.
Installing and Removing Drives
4- 7