Removing Simms - Epson ActionTower 2000 User Manual
Hide thumbs
Also See for ActionTower 2000:
- Specifications (4 pages) ,
- Read this first manual (56 pages) ,
- Product information manual (11 pages)
Table of Contents
Advertisement
6.
Repeat steps 4 and 5 for each additional SIMM.
7.
Replace the rear internal drive bracket, if necessary
Removing SIMMs
If you need to remove SIMMs from your computer (to install
different ones, for example), follow the steps below:
1.
Make sure the computer is turned off.
2.
Use the illustration on page 3-6 to locate the SIMM sockets on
the right side of the system board.
3.
You need to remove the rear internal drive bay bracket to
access the SIMM sockets. (If there is a drive mounted in this
bracket, you'll need to remove it first; see Chapter 4 for
instructions.) Remove the four screws that hold the bracket
to the back of the system, as shown on page 3-11.
4.
Set the computer down on its side
Installing and Removing Options
3-13
Advertisement
Table of Contents
