Hard Disk Drive Problems - Epson ActionTower 2000 User Manual

Hard Disk Drive Problems

A newly installed hard disk drive is not working properly.
Make sure you have installed the drive correctly and check all
cable connections. Also, check the jumper settings on your
drive.
You see a hard disk drive error when you start your system.
Run SETUP and check that your system's auto-sensing feature
is detecting the correct drive type. If auto-sensing is enabled
and SETUP displays information that does not match your
drive, you may need to define your own drive type. See
Chapter 1.
Make sure the jumpers on the system board are set correctly.
Jumpers J14 and J16 enable or disable the IDE hard disk drive
controller. See Chapter 3 for jumper information.
Make sure the jumpers on the hard disk drive are set correctly.
See the documentation that came with the drive for more
information.
You ate unable to state data on the hard disk drive.
If your drive was not configured, make sure you have
partitioned and formatted the drive correctly for your
operating system. See your operating system manual for
instructions.
Also, make sure your hard disk drive has been physically
formatted by the manufacturer. (All EPSON-supplied drives
are physically formatted at the factory.) If it has not been
physically formatted, use the format utility that came with the
drive to format it before you partition it or install the operating
system.
5-8 Troubleshooting