Table of Contents
Advertisement
Using the SVGA Feature Connector
Your computer includes an alternate SVGA interface (feature
connector) on the system board. If you install a high-resolution
graphics or full-motion, multimedia adapter card in one of the
computer's option slots, this connector allows you to access the
standard SVGA signals provided by your system circuitry.
To connect the adapter card interface to the SVGA feature
connector on your system board, locate the SVGA feature cable
included with your option card. Then follow these steps:
If you have not already done so, follow the instructions on
1.
page 4-16 to install the graphics adapter card in your
computer.
2.
Attach one end of the feature cable to the alternate SVGA
interface on the system board, as shown below. Align the
cable so the red wire along one edge is closest to pin 1 on
the connector.
3.
Connect the other end of the cable to the appropriate
interface on the adapter card. (Check your graphics card
manual for instructions.)
Installing and Removing Options
4-23
Advertisement
Table of Contents
