Table of Contents
Advertisement
Setting the
Jumpers
A jumper's setting is determined by where the jumper is placed
on the pins. For example, if the desired setting is 1-2, you place
the jumper over pins 1 and 2. (The artwork on the system board
has a notch next to pin 1 on each set of pins.)
The illustration below shows a 3-pin jumper with a 2-3 setting.
Six-pin jumpers are arranged in 2 columns of 3 pins each. The
settings are 1-2, 3-4, and 5-6. Pin 1 is the top left pin. (There is
no notch in the artwork for 6-pin jumpers. Use the orientation
of the writing on the system board to help you identify the top
pins.)
The following illustration shows a 6-pin jumper with a 1-2
setting.
4-10 Installing and Removing Options
Advertisement
Table of Contents
