Table of Contents
Advertisement
Removing an Option Card
You may need to remove an option card if you no longer need
it or if you need to access components on the system board.
Refer to the illustrations under "Installing an Option Card on
page 4-16 as you follow these steps:
1. Remove the retaining screw securing the option card to the
computer. Then pull the card straight out of the slot.
2. Set the card aside with the component side facing up.
If you are not installing another option card, replace the
3.
option slot cover and retaining screw.
4. Replace the computer's cover as described under "Replacing
the Cover" on page 4-4. Then see "Post-installation
Procedures" on page 4-26 for instructions on configuring
your computer without the option card.
Removing the Option Card Connector Board
You may want to remove the option card connector board to
access certain components on the system board, such as the
drive connectors. Follow these steps:
1. Remove any option cards. (See the instructions in the
previous section.)
Installing and Removing Options
4-19
Advertisement
Table of Contents
