Table of Contents
Advertisement
4. Push the SIMM into the socket until it is seated firmly in the
slot. Then tilt it upright, as shown below, guiding the hole
at each end of the SIMM over the retaining post at each end
of the SIMM socket. If it does not go in smoothly, do not
force it; pull it all the way out and try again.
Replace any option cards you removed. (See "Installing an
5.
Option Card on page 4-16 for instructions.)
Replace the computer's cover as described under "Replacing
6.
the Cover" on page 4-4. Then see "Post-installation
Procedures" on page 4-26 for instructions on configuring
your computer with your new memory size.
4-14 Installing and Removing Options
Advertisement
Table of Contents
