Setting The Ide Device Jumpers - Epson ActionPC 2600 User Manual

Setting the IDE Device Jumpers

Before you install any IDE device, be sure to check its jumper
settings. The jumpers indicate the master and slave
configuration of devices connected to both of the IDE
interfaces. If you have two hard disk drives, the one that
contains your operating system must be configured
master, and the other must be configured as the slave.
A table in Appendix A lists the master and slave jumper
settings for some high-capacity, IDE hard disk drives. If you
need more information, see the documentation that came with
your drive or contact the manufacturer. Every type of drive has
a unique jumper
hard disk drive on a different hard disk drive.
If you are installing another type of IDE device, such as an IDE
CD-ROM drive, check the documentation that came with the
device for the master and slave jumper settings. You must
connect these devices
described in this chapter. Use the primary interface only
IDE hard disk drives.
connect
5-2 Installing and Removing Drives
configuration. Do not use settings from one
the secondary IDE interface, as
to
the
as
to