Table of Contents
Advertisement
F39-TGR-MCL_
2.7 Installation environment
Do not install the F3S-TGR-CL system in the following types of environments:
- Areas exposed to intense interference light, such as direct sunlight
- Areas with high humidity where condensation is likely to occur
- Areas where corrosive gases are present
- Areas exposed to vibration or shock levels higher than in the specification provisions
- Areas where the product may come into contact with water
- Areas where the product may come into contact with oil that is an adhesive solvent
Do not use radio equipment such as cellular phones, walkie-talkies, or transceivers near the F39-TGR-MCL_
system.
2.8 Wiring and installation
- Make sure to perform wiring while the power supply is OFF. Otherwise, the F39-TGR-MCL_ system may fail to
operate due to the diagnosis function.
- When replacing the cable connectors with other types of connectors, use connectors that provide a proper
grade of protection.
- Do not operate the control system until 2 seconds or more (2.2 seconds or more in case of series connection)
after turning ON the power of the entire F3S-TGR-CL system.
- Be sure to route the F3S-TGR-CL system cable separate from high potential power lines or through an
exclusive conduit.
- When using a commercially available switching regulator power supply, make sure to ground the FG terminal
(frame ground terminal).
- Install the transmitter and receiver so that their vertical direction should match.
When substituting/replacing the F39-TGR-MCL_ system with an equivalent F39-TGR-
WARNING
MCL_ system, remember to set the dip-switches of the new F39-TGR-MCL_ system the same as the old
one. Failure to do so may cause serious injury or undesired loss of muting capability.
2.9 Cleaning
Do not use thinner, benzene, or acetone for cleaning, they affect the product's resin parts and paint on the case.
8
Advertisement
Table of Contents
