Compleo ADVANCED IMS bm SAM Operating Instructions Manual page 60

ShortCircuitError
LPCOverVoltageError
LPCHighTemperatureError
LPCSelftestError
AutomaticRcdTestFailed
LPCTemperatureSensorError
CurrentSensorFailure
PolarityProtectionError
samCompensationsParameters
Mismatch
samCompensationTariff
Mismatch
samMeterIdMismatch
AutomaticRcdTestSuccess
AutomaticRcdTestTripFailure
AutomaticRcdReset
ContactorTestFailed
60
h The charge point controller has detected a short circuit
between CP and PE. Inspection by qualified electrician
required.
i The charge point controller has detected an overvoltage.
Inspection by qualified electrician required.
j The charging point controller has detected a temperature
that is too high. Inspection by qualified electrician
required.
k The self-test of the charging point controller has failed.
Inspection by qualified electrician required.
m The automatic test of the RCD has failed. Inspection by
qualified electrician required.
n The charging point controller reports a temperature
sensor error. Replacement by qualified electrician
required.
The charging point controller reports a current sensor
o
error. Inspection by qualified electrician required.
p The charging point controller reports that the phases are
connected with reversed polarity. Inspection by qualified
electrician required.
q Compensation parameters in SAM and in meter do not
match. Inspection by authorized electrician required.
r Selected tariff in the meter does not correspond to that
which the meter reports as active. Inspection by
authorized electrician required.
s The SML ID of the connected meter does not correspond
to that of the meter connected to the SAM. Inspection by
authorized electrician required.
- Automatic test of the RCD successful. No action required.
- Automatic test of the residual current circuit breaker
failed. Inspection by qualified electrician required.
- The cause of the failed RCD test has not been eliminated.
Inspection by qualified electrician required.
A11XCXXXXX | 02 2023-02