Table of Contents
Advertisement
®
R&S
NRP Series
Further information:
● For details on configuration, see the user manual.
4.5
LAN PoE interface
Available only for LAN power sensors.
An Ethernet RJ45 connector is used to connect the LAN connector to a local area
network (LAN).
Supply the electrical power over the LAN PoE interface. See
"Powering the power
LAN reset button
The LAN reset button is used for resetting the Ethernet connection parameters of
the power sensor to their default values.
Power over Ethernet status LED
The power status LED shows whether the sensor is correctly powered over PoE
or not.
Color
State
Green
The sensor is powered over PoE. You can operate it using the Ethernet interface.
No light
No PoE power is present.
Network status LED
The network status LED shows whether the LAN connection to the network is
established properly or not.
Color
State
Green
The power sensor is correctly connected to the network.
It has been assigned a valid IP address, either manually or via DHCP.
Red
The power sensor is not connected to the network correctly.
Either the connection is erroneous or the sensor has not been assigned a valid
IP address yet.
Getting Started 1419.0170.02 ─ 16
sensor",
on page 14.
Power sensor tour
LAN PoE interface
Chapter 3.5,
31
Advertisement
Table of Contents
