A: Function "Flashing - preussen DimME KNX Product Manual

Staircase lighting operation
Options: Start with "1", stop with"0", Start with"1", invalid with"0", Start with"1/0",can't stop
Start with "1", stop with"0": When receive data 1 and the staircase light start run automatic,
stop with time out or stop with 0.
Start with"1", invalid with"0": When receive data 1 and the staircase light start run
automatic, 0 is invalid.
Start with"1/0", can't stop: When receive data 1/0 and the staircase light start run
automatic, Can't stop.
Brightness value: Set the brightness value of staircase light.
Fade time of brighter: (0...255s): Fade seconds in the brighter state.
Fade time of darker: (0...255s): Fade seconds in the darker state.
Duration time for brightness: (0...255 Min): Duration minutes in the brightness state.
Duration time for brightness: (0...59 Sec): Duration seconds in the brightness state
Change staircase lighting time via bus
Options: Disable / Enable
Disabel: Can't modify staircase lighting delay off time via bus, only
can be set by database.
Enable: allow modify staircase lighting delay off time via bus by user.
Warning staircase lighting
Options: Disable / Enable
Disable: Prohibition Alarm.
Enable: Allow send out warning state use warning data point for ON/OFF staircase light.

3.6.2 A: function "flashing"

Fig4.2: "flashing" window: Flashing between ON and OFF in this mode.
DimME KNX 22/35