Table of Contents
Advertisement
When the power on and the timer start.when time out, The dimming can be allowed to
operating . This function is selected by user
Cycle send general telegram(1..65535s,0-invalid)
The range of the parameter is 0 to 65535s. Zero of parameter disable the function , other of
parameter enable this function
Options: 0...65535s
The parameter set to nonzero, Device will send a telegram data cyclically when time out. Send
the value alternately between 0 and 1.
Enable sequence 1
Set the enable of the sequence.
Options: Disable / Enable
Disable: Disable the sequence function
Enable: Enable the sequence function, Set as follows
Operation mode of the sequence 1
Set the operation mode.
Options: Start with "1",Stop with "0"
Start with "0",Stop with "1"
Start with "1/0",can't stop
Start with "1",Stop with "0": When receives ", then run sequence 1,When receives 0, then
stop sequence 1.
Start with "0", Stop with "1": when receives 0, then sequence 1, When receives 1, then stop
sequence 1.
DimME KNX
Fig:1.1 "G: sequence 1"
parameter window
It includes 24 steps.
12/35
Advertisement
Table of Contents
