preussen DimME KNX Product Manual page 13

Start with "1/0",can't stop: Both receive 1 or 0,.start the sequence 1.
Control mode of the sequence 1
Set the control mode.
Options: FWD
REW
Random
FWD: Forward mode
REW: Back work mode
RANDOM: Random mode
Running mode of the sequence 1
Set the running mode
Options: Single
Cycle
Single: Run only ones.
Cycle: Cycle run.
Running time(0...255hours,0h&0m-unlimited)
Set the sequence running time .
Options: 0-255
Running time(0...59mins, 0h&0m-unlimited)
Set the sequence running time. The longest time is 59mins.
Options: 0-59
Note:Unlimited when the time set to 0h&0m.
Position after time out
If the sequence running in Cycle mode,and is run time greater than zero,After time out,the
sequence will back to this set position.
Total 24steps, configuration as following:
Step 1 configuration
Options:
invalid
Scene NO.01
...
Scene NO.64
Time for step 1(0...65535s)
Set the time for the step. The longest time is 65535s.
Time for step 1(0...999ms)
Set the time for the step. The longest time is 999ms.
Set of other steps is same as the step 1.
DimME KNX 13/35