Other Feature Compatibility; Z-Wave Compatibility; Pet Immunity Settings - Alarm.Com Knowledge Base ADC-IS-300-LP Installation Manual

Other feature compatibility

Two-Way Voice Compatibility
Images cannot be transmitted while a Two-Way Voice call is in session. When the Image Sensor is installed on a
system with Two-Way Voice over the cellular network, image transmission during an alarm may be interrupted by the
two-way session. The image transmission resumes once the call has terminated.

Z-Wave Compatibility

All IQ/DSC Touch Panels are compatible with both the Image Sensor and Z-Wave devices. No additional hardware is
needed.

Pet immunity settings

Two parts to making the Image Sensor pet immune:
1. Set PIR sensitivity settings to Low.
2. Mount set at a height of 6 feet, and install the sensor with the 6 degree mounting angle.
PIR activation and test mode
By default, the image sensor LED does not illuminate when activated by motion unless the sensor is in test mode. The
LED can be enabled by tampering the device or on the panel for each Image Sensor on a customer's account. The
Image Sensor must have successfully completed the enrollment process with a panel. When enabled, the red LED
illuminates for 3 seconds upon motion activations (at most every 3 minutes while disarmed).
To test the Image Sensor's PIR using the panel:
1. Tap Settings.
2. Enter the installer code.
3. Tap System Tests.
4. Tap Image Sensor Config.
5. Tap View for the Image Sensor to test.
6. Tap Sensor Tests.
7. Tap Start PIR Test. The screen displays a confirmation message to indicate the test mode command has been
sent.
Note: It may take up to 30 seconds for test mode to take effect.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Image_Sensor/Image_Sensor_Version_3/Qolsys_IQ_Pa...
Updated: Fri, 10 Mar 2023 20:26:10 GMT
7