Installation: Enrolling Image Sensor To Panel - Alarm.Com Knowledge Base ADC-IS-300-LP Installation Manual

Installation: Enrolling Image Sensor to panel

Image Sensors can be enrolled remotely using the Partner Portal or MobileTech app, or locally using the panel. For
information about enrolling Image Sensors remotely, see
To enroll the Image Sensor locally on an IQ Panel:
Important: For smoothest installation, learn in one Image Sensor at a time. Insert batteries only after initiating learn
mode at the panel.
1. Put the panel into add mode.
a. Using the panel, tap Settings.
b. Enter the installer code.
c. Tap Installation.
d. Tap Security Sensors.
e. Tap Auto Learn Sensor.
2. Once on the Auto Learn page, insert the batteries into the Image Sensor. The Image Sensor progresses from
blinking red to solid red to blinking yellow. This indicates that the Image Sensor is in learn mode.
3. Wait approximately 20 seconds for the Image Sensor to enroll to the panel. The screen on the control panel
displays the following: Image Sensor [X] is requesting to be added in your list. Do you want to continue? Tap OK.
The LED on the Image Sensor turns solid yellow indicating that it has successfully found the panel.
4. In the following screen, select the sensor type, sensor name, chime type, sensor group, and voice prompt
settings.
◦ The following are the default settings for each:
▪ Sensor Type ~ Image Sensors
▪ Sensor Name ~ Image Sensor
Important: Make sure the Image Sensor name is unique to that Image Sensor. The Image Sensor cannot
enroll successfully if the new Image Sensor has the same name as an Image Sensor that is already
enrolled on the panel.
▪ Chime Type ~ None
▪ Sensor Group ~ 17-IS-Away-Instant Motion
▪ Voice Prompts ~ Off
5. Once complete, tap Add New.
6. Exit Auto-Learn mode on the panel. The Image Sensor LED alternates between green and yellow while the
customer's device list is updated with Alarm.com. The LED turns solid green when the Image Sensor has been
successfully added to the customer's account.
Note: If you move (tamper) the Image Sensor after the LED has turned solid green, the Image Sensor enters test
mode for 3 minutes indicated by red LED when motion is detected. You may continue with the mounting portion of
the installation when in test mode. See the
7. After enrollment, be sure to keep the sensor and panel powered so the sensor can complete an initialization
process with the Alarm.com Network Operations Center. This process takes several minutes. Images cannot be
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Image_Sensor/Image_Sensor_Version_3/Qolsys_IQ_Pa...
Enroll an Image Sensor on a Qolsys IQ
Image Sensor LED Reference Chart
Panel.
for more details.
Updated: Fri, 10 Mar 2023 20:26:10 GMT
3