Alarm.Com ADC-IS-220-GC Installation Manual

Image sensor for 2gig go!control

Table of Contents

Download this manual

Rhein Tech Laboratories, Inc.

Client: Alarm.com

360 Herndon Parkway

Model: ADC-IS-220-GC

Suite 1400

Standards: FCC 15.247/IC RSS-210

ID's: YL6-143220ISGC/9111A-143220ISGC

Herndon, VA 20170

http://www.rheintech.com

Report #: 2015124

Appendix K:

Manual

Please refer to the following pages.

Page 37 of 49

Table of Contents

Need help?

Do you have a question about the ADC-IS-220-GC and is the answer not in the manual?

Page 1 Rhein Tech Laboratories, Inc. Client: Alarm.com 360 Herndon Parkway Model: ADC-IS-220-GC Suite 1400 Standards: FCC 15.247/IC RSS-210 ID’s: YL6-143220ISGC/9111A-143220ISGC Herndon, VA 20170 http://www.rheintech.com Report #: 2015124 Appendix K: Manual Please refer to the following pages. Page 37 of 49...
Page 2 Once uploaded, images are available for communicates with the control panel in its mounting location, enter “system test” viewing on the Alarm.com Website or an Alarm.com Smart phone app. The sensor is through the “installer toolbox” and trigger the Image Sensor.
Page 3 By default, the image sensor LED does not illuminate when activated by motion unless the sensor is in test mode. The LED can be enabled via the Alarm.com Dealer Website for each Image Sensor on a customer’s account. When enabled, the LED illuminates for 3 seconds upon motion activations (at most every 3 minutes while disarmed).
Page 4 REGULATORY INFORMATION minutes. With the sensor mounted, the tamper may also be cleared by holding the Changes or modifications not expressly approved by Alarm.com can void the user’s sensor reset button for 3 seconds to initiate a power cycle. authority to operate the equipment.