Table of Contents
Advertisement
Available languages
Available languages
•
We do not recommend washing the machines with pressure washer.
•
Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
EN
material defect.
C Always empty the grass-catcher and do not leave containers full of cut grass inside
a room.
C Never use aggressive detergents or solvents for cleaning.
DE
LUBRICATION INSTRUCTIONS
•
Lubricate the ball bearings (if equipped) in each wheel at least once a season with a light oil.
•
Lubricate the pivot points on the blade control handle and the brake cable at least once
a season with light oil. The blade control must operate freely in both directions.
CS
CUTTING BLADE
A
CAUTION!
Protect hands by using heavy gloves or a rag to grasp the cutting blades.
Tip mower with the spark plug up (the handle down). Remove the hex bolt and washer which
SK
hold the blade and blade adapter to the engine crankshaft. Remove the blade and adapter from
the crankshaft (
A
CAUTION!
Periodically inspect the blade adapter for cracks, especially if you strike a foreign
PL
object. Replace when necessary and check the machine overall.
•
For best results your blade should be sharp. The blade may be resharpened by removing
it and either grinding or filing the cutting edge keeping as close to the original bevel as
possible. It is extremely important that each cutting edge receives an equal amount of
grinding to prevent an unbalanced blade. Improper blade balance will result in excessive
HU
vibration causing eventual damage to the engine. The blade can be tested for balance for
example by balancing it on a round shaft screwdriver (
side by grinding until it balances evenly.
•
Before reassembling the blade and the blade adapter to the mower, lubricate the engine
crankshaft and the inner surface of the blade adapter with light oil.
•
Place the blade with the part number facing away from the adapter. Align the washer over
the blade and insert the hex bolt. Tighten the hex bolt to the torque listed in the Specifications.
C When you change the blade, must use the original blade (for order the blade, please
contact your local dealer or call our company).
SELF-PROPELLED SYSTEM V-BELT
(only for self-propelled mowers)
The self-propelled system V-belt is located in the working area of the mower under the cover
above the blade. If the belt pulleys are clogged or the space inside of the cover is choked with grass
residues and other dirt, the V-belt may slide down, the cover get damaged, the self-propelled
38 / 56
. 29). Bolt has a typical right-hand thread.
fig
. 30). Remove metal from the heavy
fig
Advertisement
Table of Contents
