Mounting Your Camera; Key Description - Xblitz S3 Duo User Manual

01. MOUNTING YOUR CAMERA

1. Select a place to mount the camera. It is best to set the camera so that the display
preview shows the largest possible area in front of the car. Make sure the camera
does not obstruct the driver's view while driving.
2. Stick the mounting bracket to the windshield of the vehicle then mount the
camera on it.
3. Run the power cable to the device as shown in the image above.
4. Route the cable for the rearview camera and connect it to the camera.
5. Connect the mini USB cable to the camera and insert the charger into the 12 / 24V
cigarette lighter socket.
The place of installation for the additional rearview camera included in the set is your
personal choice. The camera meets the IP67 waterproof standards (resistant to all
weather conditions).
Connecting The Rearview Camera: The cable of the rearview camera should
be connected to the AV port, which is located on the housing of the main video
recorder. Make sure the main device can see the secondary camera (if not, check the
camera settings in the main menu or check if the camera cables are properly
installed).
Connecting The Rear Camera: The cables coming from the rear camera should
be connected to the cables supplying the reverse gear lamp. Connecting the wires
this way will enable the reversing function to be activated. The external installation
of the wire will need to be well insulated and should not be overstretched.
Caution! Attach the rear camera with the mounting foot facing up. Mounting with
screws or double-sided tape.
Caution! The camera recordings will be recorded as mirror images of the initial
camera view.

02. KEY DESCRIPTION

1. POWER
A quick push on this button will turn the display panel on and o . To turn the device
on or o , the key needs to be pushed in and held for 3 seconds.
2. MENU/MODE
Holding this key for longer will open the context menu (as long as the camera is not
recording at the same time). A longer press without holding the button will allow you
to switch between the video/photo modes and file browsing. In MENU and viewing
mode, it functions as a back button. A short press of the button during recording
in video mode protects the currently recorded file from being overwritten.
14