5: Out Of Film - Magicard 360 NEO User Manual

360 NEO Card Printer – User Guide
Error code 4:21
Reason: While moving the card from the flipper to the standby position, and having seen the card reach the mid
sensor, it took too long for the mid sensor to unblock.
Error code 4:22
Reason: While trying to feed a card from the hopper, and having seen the card reach the front sensor, it took
too long for the front sensor to unblock.
Error code 4:23
Reason: While moving the card backwards to feed into the flipper, it took too long for the card to block the mid
sensor.
Error code 4:24
Reason: While moving the card from the mid sensor to the standby position, it took too long for the mid sensor
to unblock.
Error code 4:25
Reason: While moving the card to the front sensor, it took too long for the front sensor to block.
Error code 4:26
Reason: While moving the card to the rear sensor, it took too long for the rear sensor to block.

5: OUT OF FILM

Error code 5:0
Reason: While moving a dye panel edge from the dye sensor to the printhead, it took too long for the tacho
wheel to move the required amount. The film has probably either run out or snapped.
Error code 5:1
Reason: While advancing to the next dye panel, it too long for the next panel boundary to be detected.
Error code 5:2
Reason: It took too many attempts for the printer to find a particular panel of dye film (possibly because the dye
sensor needs calibration).
Error code 5:3
Reason: A valid dye film RFID tag was found, but no physical ribbon could be detected while trying to take up
the film slack.
Error code 5:4
Reason: A valid dye film RFID tag was found, but there were no shots remaining.
Error code 5:5
Reason: After printing a card, the printer was unable to decrement the number of remaining prints on the dye
film RFID tag.
39