Table of Contents
Advertisement
Save Settings
Scan the code below to make the RF settings permanent on the reader:
Save Settings
Disconnecting from the Device
You may force disconnection by reading the disconnect code below (The CR2 may not appear
disconnected in the slave Bluetooth connection manager for 10 – 15 seconds after the command is
issued). The CR2 will also disconnect after 90 seconds of inactivity (Note: You may change the radio
time out setting; however, it may reduce battery life. See Section 1.7.4.)
Bluetooth Disconnect
Reconnecting to the Device
If the device is saved in RF mode, and has a saved connection, it will automatically reconnect when:
1.
CR2 is powered up
2.
CR2 wakes from sleep mode
3.
CR2 reads another code
Note: To set up more than one device, please consult Appendix F: "QuickConnect Codes"
.7.2 - Bluetooth Radio Auto Connect
Auto Connect: After coming out of sleep mode or after powering up, the CR2 tries to auto connect with
the last Bluetooth radio with which it was connected. You may always connect by scanning a
QuickConnect code.
Scan the following codes to enable or disable Auto Connect feature for the Bluetooth radio:
Bluetooth Radio Auto Connect On (Default)
Save Settings
Bluetooth Radio Auto Connect Off
C001537_13_CR2 User Manual
18
Advertisement
Table of Contents
