Table of Contents
Advertisement
.6.4 - RS232 Cable Installation Guide
To connect the CR2 to your host computer via RS232 interface:
1. Make sure the RS232 cable is sufficiently attached to your unit (Figure 1.8).
2. Connect the RS232 interface cable to your host computer (Figure 1.9). If you are unsure of the proper
location to connect the RS232 cable please consult the manual of your host computer.
3. The RS232 interface can be purchased with a power supply. Plug the power supply adapter into the RS232
interface cable (Figure 1.10) and then plug the power adapter into a wall socket (Figure 1.11). The RS232
interface does not require additional power. However, if you are using the RS232 interface and utilizing
Batch functionality, please read the Important Note in batch section. If you are using the 1950 mAH battery
for batch mode, the CR2 will recharge the battery whenever the unit is attached to a RS232 cable that is
plugged into a wall socket.
Figure .8
4. The CR2 will power on automatically.
5. Scan the RS232 One Way Mode code then the Save Settings code to configure reader:
RS232 One Way Mode
6. Your CR2 Reader should be ready for use. Open the application on your host computer that will receive
scanned data and begin scanning.
Save Settings
Figure .9
Save Settings
Figure .0
RS232 Factory Default Settings
Mode: RS232 One Way Mode
Baud Rate: 57600
Stop Bits: 2
Data Bits: 8
Parity: None
C001537_13_CR2 User Manual
Figure .
3
Advertisement
Table of Contents
