Opticon Code Reader 2.0 User Manual page 2

Statement of Agency Compliance
The CR2 has been tested for compliance with FCC regulations and was found to be compliant
with all applicable FCC Rules and Regulations.
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, this device
must not be co-located or operate in conjunction with any other antenna or transmitter.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The CR2 has been tested for compliance to CE standards and guidelines and was found to
conform to applicable CE standards, specifically the EMC requirements EN 55024, ESD EN
61000-4-2, Radiated RF Immunity EN 61000-4-3, ENV 50204, EFT EN 61000-4-4, Conducted
RF Immunity EN 61000-4-6, EN 55022, Class B Radiated Emissions, and Class B Conducted
Emissions.
The CR2 can be set to use targeting lasers. The CR2's targeting laser emits Class 2M
radiation outside of the product per IEC 60825-1. Class 2M Laser/LED product. Do not
stare into beam or view directly with optical instruments.
The CR2 has been tested by an independent electromagnetic compatibility laboratory in
accordance with the applicable specifications and instructions.
37AW
E300884
Enlarged for
readability
Opticon voids product warranty if the hard case has been opened or
CAUTION - CLASS 3R
tampered with in any way. Opening the case may put the user at risk of
LASER RADIATION
WHEN OPEN
laser radiation exposure (Class 3R). A second Warning Label (see left) is
AVOID DIRECT EYE
EXPOSURE
placed within the casing structure as pictured (see right).
Enlarged for
readability
Caution – Use of controls or adjustments, or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
In addition,
fication Board (NCB) indicating CR 2.0 (CR2) meets all safety and quality
standards in accordance to IEC 60950-1:2001, First Edition.
Save Settings
Laser/LED Radiation
Wavelength:
Maximum Output: 650-700 nm
Laser Pulse Duration: 0.977 mSec.
LED Pulse Duration: 0.255 uSec.
A Warning Label (see left) is located on the underside of the CR2
near the battery locking mechanism as pictured (see right).
a CB Test Certificate has been issued by the National Certi-
<1mW
Laser aperature
C001537_13_CR2 User Manual i