Ps2 Cable Installation Guide; Ps2 Communication Settings - Opticon Code Reader 2.0 User Manual

.6.3 - PS2 Cable Installation Guide

1. Power off the host computer.
2. Attach the end of the PS2 cable with the single connector
3. Detach your keyboard from the host and connect the appropriate connector to the PS2 cable
4. Connect the other connector to host computer into keyboard port
The CR2 is powered by the PS2 port and does not require a power supply.
5. Set the CR2 to PS2 mode by scanning the PS2 Mode code below.
6. Scan the Save Settings code.
7. Your CR2 Reader is now ready. Open the appropriate application and begin scanning data.
Upgrade Note: CR2012 can only be upgraded using either RS-232 or USB cable.
WARNING: Using PS2 in conjunction with Batch or Bluetooth Radio mode is not recommended.
You may need to disconnect the CR2 and the keyboard which may result in the host
computer freezing.
Opticon does not guarantee compatibility with all models of laptops.

.6.3. - PS2 Communication Settings

Scan the following codes to set the reader to the PS2 communication setting:
PS2 Mode
Save Settings
C
B
A
Opticon does not guarantee compatibility
Save Settings
A
to the CR2.
C
. Power on the host computer.
A
B
C
with all models of laptops.
Reset to PS2 Factory Defaults
C001537_13_CR2 User Manual
B
.
12