Energy Efficiency - AEG CIB6646ABM User Manual

Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle on
the food and in the cavity of the
oven.
There is no good cooking perform‐
ance using the True Fan Cooking
PLUS function.
The water in the cavity embossment
does not boil.
The water comes out of the cavity
embossment.
13.2 Service data
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove the rating plate from the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

14. ENERGY EFFICIENCY

14.1 Product information for hob according to EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
38 ENGLISH
Possible cause
The clock is not set.
The necessary settings are not set.
The lamp is defective.
There was a power cut.
You left the dish in the oven for too
long.
You did not fill the cavity emboss‐
ment with water.
The temperature is too low.
There is to much water in the cavity
embossment.
.........................................
.........................................
.........................................
CIB6646ABM
Hob inside Freestanding Cooker
4
Induction
Remedy
Set the clock.
Make sure that the settings are cor‐
rect.
Replace the lamp.
Reset the clock.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Refer to "Activating the True Fan
Cooking PLUS function".
Set the temperature at least to
110°C. Refer to "Oven - Hints and
tips" chapter.
Deactivate the oven and make sure
that the appliance is cold. Wipe the
water with a cloth or sponge. Add
the correct amount of water to the
cavity embossment. Refer to "Acti‐
vating the True Fan Cooking PLUS
function".