Table of Contents
Advertisement
CAUTION!
Make sure you install the anti-tilt
protection at the correct height.
Make sure that the surface behind the
appliance is smooth.
1. Set the correct height and area for the
appliance before you attach the anti-tilt
protection.
2. Install the anti-tilt protection 176 mm
down from the top surface of the
appliance and 24 mm from the left side of
the appliance into the circular hole on the
bracket. See the illustration. Screw it into
the solid material or use applicable
reinforcement (wall).
3. You can find the hole on the left side at
the back of the appliance. See the
illustration. Put the appliance in the
middle of the space between the
cupboards (1). If the space between the
bench cupboards is larger than the width
of the appliance, you must adjust the side
measurement to centre the appliance.
3.5 Electrical installation
WARNING!
The manufacturer is not responsible if
you do not follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
WARNING!
The power cable must not touch the part
of the appliance shaded in the illustration.
24 mm
1
ENGLISH
9
Advertisement
Table of Contents
