Figure 28: Remove The Chassis; Figure 29: Fan Power Cable Of The Chassis - Owon SDS Series Service Manual

Remove the 8 screws marked in the figure below. The screws are different. The red one
is PB3*8; the green one is PM3*6. Lift the chassis a little, be aware that it is still
connected to the main board by a cable.
Grasp and pull up on the fan power cable marked in the figure below.

Figure 29: Fan power cable of the chassis

Notice for installation:
Make sure that the label of the LCD protection do not be covered by the front panel.
Section 5: Maintenance

Figure 28: Remove the chassis

29