Panda-Audio Future Impact v3 User Manual page 78

2 VCF volume of Main
Mixer
5 Portamento time
7 Final output volume of
FI
11 Filter cutoff
64 Sustain ON/OFF
65 Portamento ON/OFF
66 FI ON/OFF
127 Adjusts (logarithmically) the VCF volume
of the Main Mixer.
When CC2 is at maximum (127) then VCF
volume of Main Mixer corresponds to the
preset value in the program. This differs
from Volume Control (CC7) in two aspects:
1. It only adjusts the synth volume, it
2. It is located before the effects, so
0*/127 *0 in EWI Mode only.
When CC5 is at maximum (127) then this
corresponds to the portamento value set in
the program via the PORTA TIME slider in
the Editor.
127 Controls the entire audio output of the FI
(including any delay trails, etc). It is
independent of all program parameters. It
is smoothed and acts logarithmically.
Beware: if you use a keyboard or a MIDI
pedal to adjust the volume of the FI and
you disconnect it, the volume will only
return to the default maximum value if you
power the FI off and on again, change
program or change one of the Flexi
sources in the Editor.
64 Duplication of CC74. See below.
0 If ≥64 then it switches ON; If <64, then it
switches OFF.
Sustain stops upon change of program.
127 If ≥64 then it switches ON; If <64, then it
switches OFF.
--- If ≥64 relay switches to ON. If <64, relay
switches to OFF. (This message will also
disengage the Tuner, putting the FI into
either the ON or OFF state, depending on
the value of the message sent.)
Go to Table of Contents
does not change the input
instrument's volume;
delay trails, etc. will not be muted
when CC2 is at 0.
78