Updating The Firmware Of The Future Impact V3 - Panda-Audio Future Impact v3 User Manual

Analog modeling midi synthesizer for bass, guitar, keyboard and other instruments

Hide thumbs Also See for Future Impact v3:

User manual (71 pages)

Quick start manual (2 pages)

Table Of Contents

100

page of 100

/ 100
Contents
Table of Contents
Bookmarks

Table of Contents

● TUNE BASE ("tBS")

Value: 428-452 (Hz). (Default on reset is 440.)

This sets the tuning of the synthesizer when it is triggered using the MIDI IN.

(Triggering the synthesizer using the audio input is not affected by this parameter as

the tuning of the synthesizer is always locked to the pitch of the audio input signal.)

This also sets the base of the Tuner.

Important: If you update your FI's firmware to v3.60 from a pre-v3 version then the

Tune Base will not be at 440 Hz and so the Tuner will show "incorrect" pitch values.

You must reset the Tune Base. You can do this by performing a RESET ALL.

Alternatively, if you do not want to lose any program settings made with the

PARAMETER and EDIT dials, you can manually set the Tune Base to 440 Hz (or any

other desired value).

● INSTRUMENT MODE ("InS")

Value: bSS (Bass), SPL (Split), Gtr (Guitar), Snt (Synth), EUI (EWI). (Default on reset

is bSS.)

Choose the option for your instrument. If your instrument is not listed above then

choose either Bass or Guitar, whichever one best fits the pitch range of your

instrument.

See the

Instrument Modes

● MIDI THRU ("trU")

Value: 0, 1 (Default on reset is 0.)

If set to 0 then MIDI information received via MIDI IN will not be passed to MIDI OUT.

If set to 1 then all information received via MIDI IN will be passed to MIDI OUT (with

the exception of CC6 (Data Edit), NRPN controllers and SysEx data).