Editing The Sounds - Panda-Audio Future Impact v3 User Manual

Note 1: While in Tuner mode, the display will be blank if there is no input signal.
The Tuner is calibrated to the Tune Base value. This can be adjusted in the range of
428-452 Hz. (The default value is 440 Hz). See the
the Tune Base.
Note 2: If the Sustain
value of the sustained synth pitch and won't respond to instrument input. Disengage the
Sustain to allow the Tuner to function normally.
Note 3: When the Tuner is engaged, the Program footswitch (or its
command) can be used to set the

Editing the Sounds

For each sound, you can edit up to nine different sound parameters directly on the pedal via
the Top Panel Controls
There are also two global parameters; editing either of these affects all programs.
All the parameters are explained in the next section.
All parameters have a range of 1-9 and a default value of 5. The value is shown by the DATA
digit in the pedal's LCD.
Select a parameter using the PARAMETER dial and turn the EDIT dial to edit its value.
Editing a parameter causes an immediate audible change to the sound and the decimal
point starts blinking to indicate an unsaved edit.. Press the EDIT dial to save the changes.
Any unsaved changes will be lost when switching to a new program, pressing the ON/OFF
footswitch or powering off the pedal.
Note: At startup, the FI will automatically load whichever program you last saved
using the EDIT dial. You can thus use this function to choose the startup sound.
Upper line only
Upper and middle lines
Middle line only
Lower and middle lines
Lower line only
feature is active when entering the Tuner, the display will show the
Tap Tempo
and save the changes.
Go to Table of Contents
Sharp by > 10 cents
Sharp by > 3 cents
In tune (within ±3 cents)
Flat by > 3 cents
Flat by > 10 cents
Boot Menu for instructions on how to set
for the Delay effect.
corresponding MIDI
11