5.3
Network settings
LAN settings
The data from the brownfield level is acquired via digital or analog input, or USS (RS232). This
data is then transferred via LAN or Wi-Fi.
Under Network settings, set the parameters for the two Industrial Ethernet ports and for the
Wi-Fi connection.
There are two ways to provide the IP address:
Automatically - DHCP on: An address is assigned to the Gateway via DHCP (Dynamic Host
Configuration Protocol).
Manually: The parameters for both LAN ports are entered manually and, if necessary,
specified together with the network administrator. The lines with asterisks must be
completed.
The settings are only applied after a restart.
SIMATIC FDE Gateway
Operating Instructions, 02/2023, A5E52308942-AB
Software and commissioning
5.3 Network settings
29