Changing The Operating Mode; Preparing For The Installation - Siemens SIMATIC FDE Operating Instructions Manual

Hide thumbs Also See for SIMATIC FDE:

Table of Contents

Installing and connecting a device

4.7 Changing the operating mode

4.7

Changing the operating mode

Use the USER and RESET buttons to switch between operating modes:

Target operating mode

RUN

CONFIGURATION

Note

By pressing the RESET button, an unsaved configuration may be lost (24 V Off/On)

4.8

1. When accepting a delivery, check the packaging for visible transport damage.

If there is any transport damage at the time of delivery, make a complaint to the responsible

forwarding company.

2. Unpack the device at its installation location.

3. Keep the original packaging in case you need to transport the device again.

Note

Damage to the device during transport and storage.

If a device is transported or stored without packaging, then shocks, vibrations, pressure,

and moisture may affect the unprotected device. Damaged packaging is an indication that

ambient conditions have already had a significant impact on the device.

The device may be damaged.

Do not dispose of the original packaging. Be sure to pack the device during transport and

storage.

4. Check the contents of the packaging and the accessories for completeness and damage.

– Device

– DC connecting terminal, already plugged into the device.

Action

Press the RESET button briefly

or use the web user interface

Keep the USER button pressed until the yellow LED flashes

Operating Instructions, 02/2023, A5E52308942-AB

SIMATIC FDE Gateway

Table of Contents