Figure 3-7: Klr 10 Interface Module Electrical Connectors; Figure 3-8: Klr 10 Interface Module Sense Line Connectors - Honeywell BendixKing KLR 10 Installation Manual

Figure 3-7: KLR 10 Interface Module Electrical Connectors

Figure 3-8: KLR 10 Interface Module Sense Line Connectors

 Connect the display cable connector (10 Pin) to the IF module connector, they are both color coded
BLUE. This may be accomplished by holding the cable connector by its black strain relief and rotate it
on the display connector until the alignment keyways mate up then push towards the control module
and the retaining collar will snap into place tightly against the IF module. Verify connector is seated
completely by pulling lightly on wire and connector stays on IF module.
 Connect the power cable connector (4 pin) to the IF module connector; the connector label and the
power cable are both color coded RED. This may be accomplished by holding the cable connector by
its black strain relief and rotate it on the case power connector until the alignment keyways mate up,
then push towards the IF module and the retaining collar will snap into place tightly against the IF
module. Verify connector is seated completely by pulling lightly on wire and connector stays
on IF module.
 To remove either of the electrical connectors grip the collar and pull away from the IF module, slide
the connector off.
P/N D201305000058
Rev 1 Jul 2013
KLR 10 Installation Manual
Installation
Page 3-7