Table of Contents
Advertisement
Step 2 - When disk is in the final position, use a #40 drill to:
Drill hole 2 and cleco thru hole 2.
Drill hole 3 and cleco thru hole 3.
Drill holes 4 and 5.
Step 3 - Drill hole 5 to a diameter of .720: for clearance of the swivel base.
Step 4 - Re-drill 4 outer holes with a # 32 drill bit (.116") to provide clearance for the 4-40 mounting
screws.
P/N D201305000058
Rev 1 Jul 2013
Figure 3-4: Swivel Mount Instructions - Step 1
Figure 3-5: Swivel Mount Instructions - Step 2
Figure 3-6: Swivel Mount Instructions - Step 3
KLR 10 Installation Manual
Installation
Page 3-5
Advertisement
Table of Contents
