Table of Contents
Advertisement
KLR 10 Installation Manual
5.3
AOA PROBE ANGLES
Positive Probe Lock System
The design of the AOA probe and the mounting plate allows for the probe lock plate to positively pin the
AOA probe from any possible movement after final assembly. Due to differences in wing designs and the
number of wing mounting locations, it may become necessary to change the AOA probe angle to allow
for full scale and accurate electronic calibration. Depending on the probe lock plate pin and which side of
the AOA probe and hole is used, a range of probe angles can be locked from 35 to 90 degrees in 5
degree increments, (see figures below). Start with a 50 degree angle, if a higher or lower angle is
required, material from the probe plate must be removed for clearance of the probe to swing in the
desired direction. Once the probe lock plate and the ¼ bolt are tightened to 60 inch lbs., the AOA probe is
pinned in place.
Figure 5-1: Right Side Angles
Figure 5-2: Left Side Angles
P/N D201305000058
Appendix
Rev 1 Jul 2013
Page 5-3
Advertisement
Table of Contents
