Attaching Adapter Plate To Projector Mount - PEERLESS PARAMOUNT I-PPF Installation And Assembly Manual

Attaching Adapter Plate to Projector Mount

Guide fl anges of pivot/roll bracket (B) under fl anges of adapter plate (C) by rotating 90° as shown in fi gure 2.1.
2
Secure pivot/roll bracket (B) to adapter plate (C) by using two M5 x 10 mm screws (F) and two locknuts (G) as
shown in fi gure 2.2.
B
fi g. 2.1
FLANGES
Using 4 mm security allen wrench (M), loosen the eight screws
3
on adapter plate (C) (shown in fi gure 3.1) one full turn to allow for
adjustments of channels.
Place projector upside down and locate mounting holes. If there are
only three mounting holes remove fourth channel from adapter
plate. Center adapter plate (C) over the center of gravity of the pro-
jector while aligning mounting holes on channel feet with mounting
holes on projector as shown in fi gure 3.2 and fi gure 3.3.
NOTE: Be certain hook slots of pivot/roll bracket (B) face to the
back of the projector as shown in fi gure 3.3.
IMPORTANT: If projector does not have at least three mounting
holes, do not use this adapter plate.
fi g. 3.2
FLANGES
C
Generic Projector
TOP VIEW
F
fi g. 2.2
B
G
fi g. 3.1
fi g. 3.3
Mounting
Hole
Channel
Foot
Channel
C
14 of 16 ISSUED: 11-09-09 SHEET #: 055-9496-R-3 30.08.10
C
Loosen one full
turn for channel
adjustments
Hook slots face to
the back of projector
B
C