Advertisement
Attaching Top Tray
3
4
Thread tilting mechanism of top tray into ceiling plate (Y). Align the notch with one of the four holes of the ceiling
plate (Y) and secure tilting mechanism with a M5 x 10 mm socket pin screw (W) using 4mm security
allen wrench (R) as shown in detail 3.
Note: Slotted set screw (X) is used to jam against the threads of the tilting
mechanism to prevent any excess movement of the upper tray. Do not
overtighten screw; overtightening screw will damage threads making it
difficult to separate the products.
WOOD
JOIST
CEILING
UPPER
TRAY
Installation of Projector
4
Flip projector upside down. Attach lower tray to
the bottom of the projector using appropriate
number of screws (H,I,J,K,L,M,N,O,P),
washers (F) and spacers (C) as shown. Use
4 mm allen wrench (R) to tighten
screws (H,I,J,K,L,M,N,O,P).
Important: If projector does not have at least
three mounting holes, do not use this adapter
plate.
Note: Some projectors have feet which can be
removed and the corresponding threaded insert
can be used for a mounting hole.
Note: Projector may differ slightly in appearance.
WARNING
• Do not overtighten! Overtightening may cause
permanent damage to the projector. Torque to
26-35 in • lb (30-40 kg • cm).
Y
TILTING
MECHANISM
IMPORTANT! Be sure not to touch the
projector while tightening the set screw on
the tilting mechanism. This may cause the
image to be unaligned when you let go.
W
TILTING
MECHANISM
DETAIL 3
C
X
NOTCH
Y
SCREW
F
LOWER
TRAY
Advertisement
