To Install A Replacement Floppy Disk Drive - Nortel HMS400 Maintenance Manual

WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in "Preparing the
server for hardware maintenance" on page 96 can
.
result in electrical shock or equipment damage.
2. Disconnect the disk drive's power and signal cables.
3. Open the front panel on the server.
4. Remove and save the two screws that secure the floppy disk drive to the front of the chassis.
5. Slide the assembly toward the back of the server to disengage it from the tabs that secure the
carrier assembly to the server.
6. Remove the assembly from the chassis.
7. Remove the four screws that hold the bracket to the drive, and set them and the bracket aside.
8. Place the drive in an antistatic protective wrapper.
9. Continue with "To install a replacement floppy disk drive".

To install a replacement floppy disk drive

1. Remove the new floppy disk drive from its protective wrapper, and place it component-side up
on an antistatic surface.
2. Record the drive model and serial numbers in your equipment log.
3. Set any jumpers or switches according to the drive manufacturer's instructions.
4. Place the drive label-side up inside the carrier, and then attach the drive to the carrier with the
four screws you removed earlier.
See the following diagram:
Nortel Hospitality Messaging Server 400
Maintenance Guide
April
2006
-124-