Replacing The Cd-Rom Drive; Introduction; Cd-Rom Drive Installation Overview; To Remove The Cd-Rom Drive - Nortel HMS400 Maintenance Manual

Replacing the CD-ROM Drive

Introduction

The CD-ROM drive is preinstalled at the factory. However, if it becomes faulty, follow the
procedure in this section to replace it.
CAUTION
Risk of electrical damage
Use only a CD-ROM drive that is approved by Nortel
Networks.
.

CD-ROM drive installation overview

To remove the CD-ROM drive

Note: The CD-ROM drive is installed in the top bay.
1. Prepare the server for CD-ROM drive replacement as follows:
a. Shut down the server, and then disconnect the power and peripheral device cables.
b. Remove the side cover.
c. Remove the upper fan holder foam.
WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in "Preparing the server for
hardware maintenance" on page 96 can result in electrical
.
shock or equipment damage.
2. Disconnect the faulty drive's power and signal (IDE) cables.
Nortel Hospitality Messaging Server 400
Maintenance Guide
April
2006
-121-