Loewe Individual 55 Manual page 23

n
Individual 40-55
User guide
Initial installation
Setting options for DVB-T reception:
If you have not selected DVB-T antenna in the list of available anten-
nas: Proceed to Setting options for DVB-C reception on page 24.
If a CA module is plugged in during Initial installation and if Stations
in the special station list was selected in Extent of station
search (see page 22), the routine continues with the step Sup-
ply voltage (see right column).
Network
selection
If several networks are available via DVB-T, you can
decide which network you want to receive your chan-
nels from.
56 Select network,
Conclude this step (for navigation refer to page 18).
Settings
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and additional
card.
Note: The newly selected parameter in each case must be confirmed with the
Scrambled stations
Search method
Accept Logical Channel Number
Back with
5634 Select and adapt settings for DVB-T reception.
OK Adopt settings.
Network selection
Please state from which network you wish to receive your station.
Freeview
other network
Back with Proceed with
DVB-T settings
no yes
Channel search Frequency search
no yes
Proceed with
- 23 -
Scrambled
stations
Search
method
Accept
Logical
Channel
Number
Supply
voltage
button.
OK
You can state whether coded stations are to be
searched for in the search/update.
save all found scrambled stations. However, these
stations can only be received in connection with a CA
module and the appropriate Smart Card.
the CA module is described on page 82.
If you want to run the station search independently
of the channel grid, select Frequency search for
the search method.
In various countries, digital stations (DVB-T) are
transmitted with a preset channel number per
station, known as Logical Channel Numbers (LCN).
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted (see Move block
/ Change order on page 96).
Conclude this step (for navigation refer to page 18).
Supply voltage DVB-T antenna
Please state here whether your DVB-T antenna needs a supply voltage. Antennas with an
integrated amplifier need a supply voltage on the antenna line.
no (0V) yes (5V)
Back with Proceed with
34 Select supply voltage no / yes.
If you use a DVB-T antenna that requires a supply
voltage (active antenna) and which is not already
supplied via a power adaptor, then select yes (5V)
for the antenna's power supply.
How to align your DVB-T antenna is described on
page 123.
Conclude this step (for navigation refer to page 18).
Select yes to
Handling of