Loewe Individual 55 Manual page 103

Individual 40-55
User guide
Software update via USB storage device
To do this, plug the USB stick with the downloaded software (see
page 102) into a free USB port of the TV set (see connections pages
11 and 12).
Calling Software update
HOME: Call Home view.
3456 Mark System settings,
OK call System settings.
65 Mark Control,
4 go to next column.
6 5 Mark Software,
4 go to next column.
6 5 Mark Software-Update,
4 go to next column.
6 5 Mark Via USB,
4 call Software update.
The version of the software package that is
currently installed will be displayed.
Current software: V1.3.0.0
... ... Via USB
To load a new piece of software, you first need to search
for said software on a USB storage device that is
connected (e.g. USB stick). Press the
search.
Proceed with
8 Proceed.
The TV set searches for a new software package
on the USB stick.
If a new software version is available after the search,
an on-screen message appears (see right hand
column).
If several different software packages are found on the
USB stick, the latest software package is always used.
If no new software package was found in the search:
BACK: End of wizard.
- 103 -
key to start the
Cancel with
New software package found
SOFTWARE-UPDATE WIZARD - Current software SOFTWARE-UPDATE WIZARD - Current software
Current software: 1.9.6.0 Current software: 1.9.6.0
... ... Via USB
To load a new piece of software, you first need to search To load a new piece of software, you first need to search
for said software on a USB storage device that is for said software on a USB storage device that is
connected (e.g. USB stick). Press the connected (e.g. USB stick). Press the
the search. the search.
Proceed with Proceed with
8 Proceed starts loading of the new software.
Or:
BACK: End of wizard.
The update will then not be carried out.
Load new software package
Updating software Updating software
The "V5.60.0.0 F2" is being programmed, please wait ...
... ... Via USB
Note: The loading and programming process can take up to Note: The loading and programming process can take up to
approx. 50 minutes in total. Please do not switch off your approx. 50 minutes in total. Please do not switch off your
TV set at the mains during this time. TV set at the mains during this time.
The software is loaded in several steps. The total loading
and programming process can take up to approx. 50
minutes in total.
Please do not switch off your TV set with the mains
switch during the entire loading and programming
process.
You will be informed at the end of the update.
To make your TV set completely ready for use again,
please turn it off and on again at the mains.
key to start key to start
Cancel with Cancel with
60%